73
views
0
recommends
+1 Recommend
0 collections
    0
    shares
      • Record: found
      • Abstract: found
      • Article: found
      Is Open Access

      Torsion and Antero-Posterior Bending in the In Vivo Human Tibia Loading Regimes during Walking and Running

      research-article

      Read this article at

      Bookmark
          There is no author summary for this article yet. Authors can add summaries to their articles on ScienceOpen to make them more accessible to a non-specialist audience.

          Abstract

          Bending, in addition to compression, is recognized to be a common loading pattern in long bones in animals. However, due to the technical difficulty of measuring bone deformation in humans, our current understanding of bone loading patterns in humans is very limited. In the present study, we hypothesized that bending and torsion are important loading regimes in the human tibia. In vivo tibia segment deformation in humans was assessed during walking and running utilizing a novel optical approach. Results suggest that the proximal tibia primarily bends to the posterior (bending angle: 0.15°–1.30°) and medial aspect (bending angle: 0.38°–0.90°) and that it twists externally (torsion angle: 0.67°–1.66°) in relation to the distal tibia during the stance phase of overground walking at a speed between 2.5 and 6.1 km/h. Peak posterior bending and peak torsion occurred during the first and second half of stance phase, respectively. The peak-to-peak antero-posterior (AP) bending angles increased linearly with vertical ground reaction force and speed. Similarly, peak-to-peak torsion angles increased with the vertical free moment in four of the five test subjects and with the speed in three of the test subjects. There was no correlation between peak-to-peak medio-lateral (ML) bending angles and ground reaction force or speed. On the treadmill, peak-to-peak AP bending angles increased with walking and running speed, but peak-to-peak torsion angles and peak-to-peak ML bending angles remained constant during walking. Peak-to-peak AP bending angle during treadmill running was speed-dependent and larger than that observed during walking. In contrast, peak-to-peak tibia torsion angle was smaller during treadmill running than during walking. To conclude, bending and torsion of substantial magnitude were observed in the human tibia during walking and running. A systematic distribution of peak amplitude was found during the first and second parts of the stance phase.

          Related collections

          Most cited references44

          • Record: found
          • Abstract: found
          • Article: not found

          Loading of the knee joint during activities of daily living measured in vivo in five subjects.

          Detailed knowledge about loading of the knee joint is essential for preclinical testing of implants, validation of musculoskeletal models and biomechanical understanding of the knee joint. The contact forces and moments acting on the tibial component were therefore measured in 5 subjects in vivo by an instrumented knee implant during various activities of daily living. Average peak resultant forces, in percent of body weight, were highest during stair descending (346% BW), followed by stair ascending (316% BW), level walking (261% BW), one legged stance (259% BW), knee bending (253% BW), standing up (246% BW), sitting down (225% BW) and two legged stance (107% BW). Peak shear forces were about 10-20 times smaller than the axial force. Resultant forces acted almost vertically on the tibial plateau even during high flexion. Highest moments acted in the frontal plane with a typical peak to peak range -2.91% BWm (adduction moment) to 1.61% BWm (abduction moment) throughout all activities. Peak flexion/extension moments ranged between -0.44% BWm (extension moment) and 3.16% BWm (flexion moment). Peak external/internal torques lay between -1.1% BWm (internal torque) and 0.53% BWm (external torque). The knee joint is highly loaded during daily life. In general, resultant contact forces during dynamic activities were lower than the ones predicted by many mathematical models, but lay in a similar range as measured in vivo by others. Some of the observed load components were much higher than those currently applied when testing knee implants. Copyright 2010 Elsevier Ltd. All rights reserved.
            Bookmark
            • Record: found
            • Abstract: found
            • Article: not found

            In vivo measurement of human tibial strains during vigorous activity.

            Our understanding of mechanical controls on bone remodeling comes from studies of animals with surgically implanted strain gages, but in vivo strain measurements have been made in a single human only once. That study showed that strains in the human tibia during walking and running are well below the fracture threshold. However, strains have never been monitored in vivo during vigorous activity in people, even though prolonged strenuous activity may be responsible for the occurrence of stress fractures. We hypothesized that strains > 3000 microstrain could be produced on the human tibial midshaft during vigorous activity. Strains were measured on the tibiae of two subjects via implanted strain gauges under conditions similar to those experienced by Israeli infantry recruits. Principal compressive and shear strains were greatest for uphill and downhill zigzag running, reaching nearly 2000 microstrain in some cases, about three times higher than recorded during walking. Strain rates were highest during sprinting and downhill running, reaching 0.050/sec. These results show that strain is maintained below 2000 microstrain even under conditions of strenuous activity. Strain rates are higher than previously recorded in human studies, but well within the range reported for running animals.
              Bookmark
              • Record: found
              • Abstract: found
              • Article: not found

              Determining the movements of the skeleton using well-configured markers.

              The problem of determining skeletal movements in three dimensions by using a number of landmarks is treated. We present a method that determines the motion of a rigid body by using the positions of the landmarks in least-squares sense. The method uses the singular value decomposition of a matrix derived from the positions of the landmarks. We show how one can use this method to express movement of skeleton segments relative to each other. As many others have pointed out, the movement can be very ill determined if the landmarks are badly configured. We present a condition number for the problem with good geometrical properties. The condition number depends on the configuration of the landmarks and indicates how to distribute the landmarks in a suitable way.
                Bookmark

                Author and article information

                Contributors
                Role: Editor
                Journal
                PLoS One
                PLoS ONE
                plos
                plosone
                PLoS ONE
                Public Library of Science (San Francisco, USA )
                1932-6203
                2014
                14 April 2014
                : 9
                : 4
                : e94525
                Affiliations
                [1 ]Key Laboratory for Space Bioscience and Biotechnology, School of Life Sciences, Northwestern Polytechnical University, Xi'an, China
                [2 ]Division of Space Physiology, Institute of Aerospace Medicine, German Aerospace Center, Cologne, Germany
                [3 ]Institute of Biomechanics and Orthopaedics, German Sport University Cologne, Cologne, Germany
                [4 ]Department of Orthopaedic and Trauma Surgery, University of Cologne, Cologne, Germany
                [5 ]Institute for Biomedical Research into Human Movement and Health, Manchester Metropolitan University, Manchester, United Kingdom
                University of Utah, United States of America
                Author notes

                Competing Interests: The authors have declared that no competing interests exist.

                Conceived and designed the experiments: PFY MS BG TK GPB LPM JR. Performed the experiments: PFY MS BG TK GPB LPM JR. Analyzed the data: PFY MS BG TK GPB LPM JR. Contributed reagents/materials/analysis tools: PFY MS BG TK GPB LPM JR. Wrote the paper: PFY MS BG TK GPB LPM JR.

                Article
                PONE-D-13-23714
                10.1371/journal.pone.0094525
                3986088
                24732724
                53e0b894-04c1-4991-8c09-e1c4a6230416
                Copyright @ 2014

                This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

                History
                : 7 June 2013
                : 17 March 2014
                Page count
                Pages: 12
                Funding
                No current external funding sources for this study.
                Categories
                Research Article
                Biology and Life Sciences
                Anatomy
                Biological Tissue
                Connective Tissue
                Bone
                Musculoskeletal System
                Biomechanics
                Bone and Joint Mechanics
                Biophysics
                Medicine and Health Sciences
                Physical Sciences
                Physics

                Uncategorized
                Uncategorized

                Comments

                Comment on this article